Yağlayıcı Kataloğu

GRAFOLOG H 2200 is an extreme pressure, high load application grease with a high content of ultrafine and natural graphite highly purified. Its special additives and aluminium complex soap give to GRAFOLOG H 2200 a remarkable resistance to scuffing of the metallic surface in contact even with high temperature, high load and low speed conditions.

GRAFOLOG H 00 R is a grease that has been specifically formulated to provoke physical wear through a chemical reaction which is necessary for the lapping in of metallic parts in contact. GRAFOLOG H 00 R creates a controlled wear in the zones that are under higher load. These high load areas which create more pressure and temperature, sets off the lapping reaction until the surfaces are equalized.

GEAR FLUID 550 D is a half synthetic oil in a solvent developed for the lubrication of slow open gears at with very high power. Its high viscosity at all temperatures boosted with specific additives gives it remarkable extreme pressure performances with a functional lubricant film from 0°C to +120°C. GEAR FLUID 550 D is free from chlorine, heavy metals and solid particles. GEAR FLUID 550 D meets the requirements of ANSI/AGMA 9005-E2, Annex D.

GEAR FLUID P is an adhesive oil free from bitumen and strongly additivated which gives it very good extreme pressure properties. Its efficiency is reinforced by its high viscosity at all temperatures and the film lubricant resistance from 0 to +120°C.

GEARLOG 1000 is indicated for the lubrication of high power open gears and particularly for high open gears of rotary kilns. GEARLOG 1000 is mainly used in raw material industries (cement, mining and chemical). Direction for use: GEARLOG 1000 can be applied by immersion bath, direct or paddle wheel, circulation or spray. It is recommended to heat the distribution systems for temperatures below 5°C.

GEARLOG 500 is indicated for the lubrication of high power open gears and particularly for high open gears of rotary kilns. GEARLOG 500 is mainly used in raw material industries (cement, mining and chemical). Direction for use: GEARLOG 500 can be applied by immersion bath, direct or paddle wheel, circulation or spray. It is recommended to heat the distribution systems for temperatures below 5°C.

GEARLOG 200 is indicated for the lubrication of high power open gears and particularly for high open gears of rotary kilns. GEARLOG 200 is mainly used in raw material industries (cement, mining and chemical). Direction for use: GEARLOG 200 can be applied by immersion bath, direct or paddle wheel, circulation or spray. It is recommended to heat the distribution systems for temperatures below 5°C.